Operation Guide

X-C13SG_REV1.6_Operation Guide

X-C13SG

Shanghai RaymonIoT Technology Co., Ltd.

3. DEBUG AND PROGRAM

3.1. Enablle Debug Log

Open SecureCRT(baud rate 115200), refer to previous chapter to enter AT command mode, and input

“AT+LOG=1,1” to enable Debug UART to output log, “AT+LOG=0” to close log output.

Module Debug UART pin is as following, use USB to TTL board to connect module GND, debud_TX(IO16),

UART1_RX(IO7)(Refer to module manual for detailed debug UART Pin).

Follow the following picture to enable secureCRT tools file log function.

D:\session_log\%H\%Y-%M-%D_%h%m%s.log

[%Y%M%D_%h%m%s]