Operation Guide

X-C13SG_REV1.6_Operation Guide

X-C13SG

Shanghai RaymonIoT Technology Co., Ltd.

+ok=<time><CR><LF><CR><LF>

Parameters:

time: networ time, for example: 2013-10-9 16:10:42 Wed，if it shows Not Available means that the time

calibration function is not enabled or the module doesn’t connect to the internet..

1.3.3.81. AT+NTPSER

Function: Set/Query NTP server IP address.

Format:

Query Operation:

AT+NTPSER<CR>

+ok=<ipaddress><CR><LF><CR><LF>

Set Operation:

AT+NTPSER=< ipaddress ><CR>

+ok<CR><LF><CR><LF>

Parameters:

ipaddress: NTP network server IP address, cn.ntp.org.cn (default value).

1.3.3.82. AT+BLE

Function: Config/Query BLE UART throughput function

Format:

Query Operation:

AT+BLE<CR>

+ok=<status><CR>< LF><CR>< LF>

Set Operation

AT+BLE=<status[,opt]><CR>

+ok<CR>< LF><CR>< LF>

Parameters:

staus: Enable/Disable BLE UART throughput function

on: Enable.

off: Disable, default

opt: function code, save to flash or not, option parameter. if not fill in, default is 1

0: setting not saved to flash

1: setting saved to flash

1.3.3.83. AT+BLENAME

Function: Config/Query BLE broadcast name, valid afterreboot.

Format:

Query Operation:

AT+BLENAME<CR>

+ok=<name1,name2><CR>< LF><CR>< LF>

Set Operation:

AT+BLENAME=<name1,name2><CR>

+ok<CR>< LF><CR>< LF>

Parameters:

Name1: BLELINK config mode BLE name default XM, 26 characters max.

Name2: Normal working BLE name, default is X-C13SL, 26 characters max.