Operation Guide

X-C13SG_REV1.6_Operation Guide

X-C13SG

Shanghai RaymonIoT Technology Co., Ltd.

LABEL OF THE END PRODUCT

The final end product must be labeled in a visible area with the following：

Host must Contains FCC ID: 2A8LU-X-C13SG. If the size of the end product is larger than

12x10cm, then the following FCC part 15.19 statement has to also be available on the label: This

device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Information on test modes and additional testing requirements5

Data transfer module demo board can control the EUT work in RF test mode at specified test channel.

Additional testing, Part 15 Subpart B disclaimer

The module without unintentional-radiator digital circuit, so the module does not required an evaluation

by FCC Part 15 Subpart B. The host should be evaluated by the FCC Subpart B.

ATTENTION

This device is intended only for OEM integrators under the following conditions: 1) The antenna must

be installed such that 20 cm is maintained between the antenna and users, and

2) For all produc

ts market in US, OEM has to limit the Operating Frequency: 2412MHz~2462MHz,

2402MHz~2480MHz by supplied firmware programming tool. OEM shall not supply any tool or info to

the end‐user regarding to Regulatory Domain change.

USERS MANUAL OF THE END PRODUCT:

In the user manual of the end product, the end user has to be informed to keep at least 20cm

separation with the antenna while this end product is installed and operated. The end user has to be

informed that the FCC radio‐frequency exposure guidelines for an uncontrolled environment can be

satisfied. The end user has to also be informed that any changes or modifications not expressly

approved by the manufacturer could void the user's authority to operate this equipment.