Operation Guide

X-C13SG_REV1.6_Operation Guide

X-C13SG

Shanghai RaymonIoT Technology Co., Ltd.

1.3.3.41. AT+WAKEY

Function: Set/Query AP Wi-Fi secruity parameters. Setting is valid after reset.

Format:

Query Operation:

AT+WAKEY<CR>

+ok=<auth,encry,key><CR><LF><CR><LF>

Set Operation:

AT+WAKEY=< auth,encry,key><CR>

+ok<CR><LF><CR><LF>

Parameters:

auth:

OPEN, WPA2PSK

encry:

NONE: When “auth=OPEN” available;

AES: When “auth=WPA2PSK” available;.

key: security code, ASCII code, 8~63 bytes.

1.3.3.42. AT+WADHCP

Function: Set/Query AP DHCP server status; Setting is valid after reset

Format:

Query Operation:

AT+WADHCP<CR>

+ok=<status>,<ip1>,<ip2><CR><LF><CR><LF>

Set Operation:

AT+WADHCP=<status>[,ip1,ip2]<CR>

+ok<CR><LF><CR><LF>

Parameters:

status: AP’s DHCP server function status:

on: DHCP Server open.

off: DHCP Server close

ip1: DHCP allocate IP start value

ip2: DHCP allocate IP end value

1.3.3.43. AT+WALK

Function: Query MAC address of STA device connecting to module AP.

Format:

Query Operation:

AT+WALK<CR>

+ok=<status><CR><LF><CR><LF>

Parameters:

status: MAC address of STA device connecting to module AP

No Connection: No STA device connecting to module AP;.

1.3.3.44. AT+WALKIND

Function: Enable/Disable indication of module AP connection status.

Format:

Query Operation: