Operation Guide

X-C13SG_REV1.6_Operation Guide

X-C13SG

Shanghai RaymonIoT Technology Co., Ltd.

AT + APLINK<CR>

+ok<CR>< LF><CR>< LF>

Note: Reboot to quit this APLINK config mode.

1.3.3.28. AT+BLELINK

Function: Start SmartBLELink function

Format:

Set Operation:

AT + BLELINK<CR>

+ok<CR>< LF><CR>< LF>

Note: Reboot to quit BLELINK config mode

1.3.3.29. AT+WMDCH

Function: Set Wi-Fi Auto Switch Function. Setting is valid after reset.

Format:

Query Operation:

AT+WMDCH<CR>

+ok=<mode><CR><LF><CR><LF>

Set Operation:

AT+WMDCH=<mode><CR><LF><CR><LF>

+ok<CR><LF><CR><LF>

Parameters:

mode: Wi-Fi Auto Switch Mode.

off: 关 Disable Wi-Fi auto switch. When response with auto, it is the same as off

on: Enable Wi-Fi auto switch. When the module (STA mode) fail to connect to router, it will switch to AP

mode itself in one minute.

1.3.3.30. AT+WSMAC

Function: Set/Query Module STA MAC address parameters. Setting is valid after reset.

Format:

Query Operation:

AT+WSMAC<CR>

+ok=<mac_address><CR><LF><CR><LF>

Set Operation:

AT+WSMAC=<mac_address><CR>

+ok<CR><LF><CR><LF>

Parameters:

mac_address: module MAC address, such as 90EB48000C60

1.3.3.31. AT+WSSSID

Function: Set/Query Wi-Fi associated AP SSID parameters. Setting is valid after reset.

Format:

Query Operation:

AT+WSSSID<CR>

+ok=<ap’s ssid><CR><LF><CR><LF>

Set Operation:

AT+WSSSID=<ap’s ssid ><CR>