Operation Guide

X-C13SG_REV1.6_Operation Guide

X-C13SG

Shanghai RaymonIoT Technology Co., Ltd.

Format:

Query Operation:

AT+WMODE<CR>

+ok=<mode><CR><LF><CR><LF>

Set Operation:

AT+WMODE=<mode><CR>

+ok<CR><LF><CR><LF>

Parameters:

Mode: Wi-Fi work mode.

STA

AP+STA

1.3.3.25. AT+WSCAN

Function: Scan AP, max show 50 item.

Format:

Query Operation:

AT+WSCAN<CR>

+ok=<ap_site><CR><LF><CR><LF>

Parameters:

ap_site: AP searched..

ap_ssid: search specific AP SSID

1.3.3.26. AT+CONFIGLINK

Function: Config/Query Smart config method.

Format:

Query Operation:

AT+CONFIGLINK<CR>

+ok=<status,[ap_prefix,ap_key]><CR>< LF><CR>< LF>

Set Operation:

AT+CONFIGLINK=<status,[ap_prefix,ap_key]><CR>

+ok<CR>< LF><CR>< LF>

Parameters:

staus: Set Smart config mode function

0(Default): Enable BLELINK config.

Set reload pin (0.2s < “Low” < 1.5s) to trigger into this config mode

1: Enable APLINK config

Set reload pin (0.2s < “Low” < 1.5s) to trigger into this config mode.

2: Enable BLELINK and APLINK config.

Set reload pin (0.2s < “Low” < 1.5s) to trigger into BLELINK config mode, When in BLELINK config mode, set

reload again to trigger into APLINK config mode. Repeat this cycle after set reload

ap_prefix: APLINK module AP SSID, default is softap.

ap_key: APLINK module AP password, blank for no password, password length 8~20.

1.3.3.27. AT+APLINK

Function: Start SmartAPLink function(Recommend to use this)

Format:

Set Operation: