Operation Guide

X-C13SG_REV1.6_Operation Guide

X-C13SG

Shanghai RaymonIoT Technology Co., Ltd.

INTEGRATION INSTRUCTIONS

FCC Rules

The X-C13SG is an Wi-Fi 2.4G/BLE Module with digitally modulated systems using an DSSS and

OFDM modulation. It operates on the 2412-2462 MHz band and 2402-2480MHz, therefore, is within

U.S. FCC part 15.247 standard.

Modular installation instruction

1, X-C13SG Integrates high-speed GPIO and peripheral interface. Please pay attention to the

installation direction (pin direction).

2,Antenna could not be in no-load state when module is working. During debugging, it is suggested to

add 50 ohms load to the antenna port to avoid damage or performance degradation of the module

under long-time no-load condition.

3,When the module needs to output 15.11dBm or more power, it needs a voltage supply of 3.3V or

more to achieve the expected output power.

4,When working at full load, it is recommended that the entire bottom surface of the module be

attached to the housing or heat dissipation plate, and it is not recommended to conduct heat

dissipation through air or screw column heat conduction.

RF exposure considerations

To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and

operated with minimum distance between 20cm the radiator your body: Use only the supplied

antenna.

Antennas

The X-C13SG is an Wi-Fi 2.4G/BLE Module beams signals and communicates with its antenna, which

is X-C13SG:PCB Antenna; X-C13SG-0:External Antenna(Peripherals). The PCB Antenna gain is X-

C13SG:2.4 dBi; X-C13SG-0:2dBi (Peripherals)