Operation Guide

X-C13SG_REV1.6_Operation Guide

X-C13SG

Shanghai RaymonIoT Technology Co., Ltd.

1.3.3.2. AT+HELP

Function: HELP command.

Format:

AT+HELP<CR>

+ok=<command help><CR><LF><CR><LF>

Parameters:

command help: AT Command introduction.

1.3.3.3. AT+VER

Function: Query module software version information.

Format:

AT+VER<CR>

+ok=<ver><CR><LF><CR><LF>

Parameters:

ver: Module software version information.

1.3.3.4. AT+RST

Function: Reset module.

Format:

AT+RST<CR>

1.3.3.5. AT+ECHO

Function: Open/Close show back function.

Format:

Set Operation:

AT+ECHO=<status><CR>

+ok<CR><LF><CR><LF>

Parameters:

status: Echo status

on: Open Echo

off: Close Echo

module firstly switch from transparent transmission to configuration mode, show back status is open,

input “AT+ECHO” to close show back function, input “AT+ECHO” again to open show back function, use

AT+ECHO=on/off command to save the echo status.

1.3.3.6. AT+RESTORE

Function: Module restore to factory default setting

Format

AT+RESTORE<CR>

+ok=rebooting…<CR><LF><CR><LF>

When operate this command, module will restore to factory default setting and reboot.

1.3.3.7. AT+CMDGD

Function: Set/Query AT command prefix character for sending AT command in throughput mode. Setting

is valid after reset.