Installation guide

Chapter 1: Before you begin 1
Chapter 1: Before you begin
The ST70 Autopilot controller is the interface to your autopilot system. It must be
installed correctly following the instructions in this guide. For a safe and successful
installation, we recommend a certified installation.
1.1 Installation overview
The key steps in the procedure are as follows:
Planning
1. Plan your system.
2. Decide where to locate the ST70 autopilot controller.
3. Check parts.
Installing
1. Fit ST70 cable to SeaTalk or SeaTalk
ng
system.
2. Cut required holes.
3. Connect the controller.
4. Test the system.
5. Secure the controller in position.
1.2 Certified installation
Raymarine recommends certified installation by a Raymarine approved installer. A
certified installation qualifies for enhanced warranty benefits. Contact your
Raymarine dealer for further details and refer to the separate warranty card packed
with your product.
1.3 Further assistance
Comprehensive customer support is available online and by telephone.
www.raymarine.com
In the Customer Service area you will find:
• Frequently Asked Questions (FAQs).
• Servicing information.
• Email access to the Raymarine Technical Support Department.
• Details of Raymarine agents worldwide.
Telephone helpline
In the USA
[phone] extension 2444
In the UK, Europe, the Middle East or the Far East
[phone] (voice)
[phone] (fax)
87071-1.book Page 1 Monday, April 21, 2008 3:34 PM