Product specifications

Chapter 4: Calibration

4.3 Intermediate calibration

Intermediate calibration enables you to:

• Check the instrument software version.

• Check the instrument status - either master (shown as RPTR NO) or

repeater (shown as RPTR YES). You cannot change this.

Follow the procedure in the Intermediate calibration flow diagram.

Software

version

D4765-2

for approximately 4 secondshold down and

Instrument

status

To return to normal operation from either screen,

WIND

CAL

During normal operation

ST40

WINDST40

for approximately 2 secondsandhold down

INTERMEDIATE CALIBRATION

Note:

If there is no key activity when

the Software version screen

is displayed, calibration will

time out to normal operation

after 5 seconds

4.4 Dealer calibration

Dealer calibration enables you to set:

• User calibration on/off.

• Boat show mode on/off.

Dealer calibration also gives access to the Factory defaults screen.

This enables you to reapply the factory settings if you want to reset the

instrument to a known operating condition.

Follow the procedure in the Dealer calibration flow diagram.

160_3c04.p65 01/05/01, 16:1625