Specifications

Chapter 2: Setting Up Graphic Displays 7-2-13
ST290 Instrument System Owner’s Handbook
The DISPLAY OPTIONS setup chapter enables you to set:
• General options.
• Trip counters.
• Race timers.
• Data resolution.
• Date & time.
• Position logging interval.
• Remote control configuration.
General options
You can set the following general options (see Figure 2-14 ):
• HEADING information to be displayed as either MAG(netic) or TRUE.
• CHAP TITLES. Determines the method of chapter and page selection,
during Normal operation. The options are MENU/POPUP.Theseare
described in Section 2, Chapter 2.
• PAGE VIEWED. Determines which page is displayed when you go to a
new chapter during Normal operation. The options are:
• FIRST - to display the first page in the chapter.
• PREV. - to display the page that was displayed when the relevant
chapter was last used.
• KEY BEEP. Either (on) or (off).
• PILOT POPUP. Either (on) or (off).
• PILOT CAL.Either (on) or (off). When set to on, the Pilot Basic,
Seatrial and Advanced Calibrationare accessible. When PILOT CAL.is
set to off, these Pilot calibration functions are bypassed.
Figure 2-14: Display general options setup
D5939-1
81183_2 S7.book Page 13 Wednesday, May 7, 2003 1:52 PM