Specifications

MADMAN Marine Electronics

V2.1

INSTALLATION

MOUNTING

The AP Wireless Remote Control (AP WRC) can be mounted anywhere inside the boat’s

cabin where it will be protected from water and mechanical damage.

There are two flanges on the box which have holes provided for mounting with screws (2) to

any flat surface. Any orientation of the box is acceptable but take into account access to the

on/off switch when selecting a mounting location and orientation.

The unit does not need to be in line of sight of the transmitter fob so can be hidden out of

view if desired.

ELECTRICAL CONNECTIONS

The AP WRC unit is supplied with 5m of 4-core cable of which only 3 cores are used as

follows:

 RED +12V supply

 BLACK 0V

 WHITE SeaTalk data

Run the cable from the mounting location to the rear of the Autopilot bulkhead connector.

The route of the cable should be selected to avoid sources of interference such as radio

transmitters, antenna cables and other electronic instruments.

After ensuring the Autopilot power is turned off connect the three wires to the pins at the

back of the Autopilot bulkhead connector as shown in Figure 3 on next page.

Reassemble the bulkhead connector, plug in the Autopilot (ST1000+ or ST2000+) and switch

on the Autopilot supply. Leave the on/off button of the AP WRC set to off (‘O’) – see Figure

2 below.

Figure 2 Power Switch (off position shown)