Specifications

ManualsBrandsRaymarine ManualsAircraftST1000+

MADMAN Marine Electronics

V2.1

Model AP-WRC1

Wireless Remote Control for

ST1000+ & ST2000+ Autopilot.

INTRODUCTION

The Autopilot Wireless Remote Control (AP WRC) is a low cost and easily installed system

which provides similar functionality to the buttons on a Raymarine ST1000+ or ST2000+

Autopilot.

The system consists of a box which houses the wireless receiver & electronics for

communicating with the Autopilot, 5m of cable and two (2) remote control button fobs

(transmitters) – see Figure 1 below.

Using the AP WRC allows control of an ST1000+, ST2000+ Autopilot without requiring the

user to be beside the tiller in order to make course changes or auto-tack. It is ideal for

single-handed or short-handed crews who will now be able to steer from the front of the

boat (for example when changing sails or setting/retrieving a spinnaker) or even from inside

the cabin.

Figure 1 Autopilot Wireless Remote Control System

Summary of content (8 pages)

PAGE 1
MADMAN Marine Electronics Model AP-WRC1 Wireless Remote Control for ST1000+ & ST2000+ Autopilot. INTRODUCTION The Autopilot Wireless Remote Control (AP WRC) is a low cost and easily installed system which provides similar functionality to the buttons on a Raymarine ST1000+ or ST2000+ Autopilot. The system consists of a box which houses the wireless receiver & electronics for communicating with the Autopilot, 5m of cable and two (2) remote control button fobs (transmitters) – see Figure 1 below.
PAGE 2
MADMAN Marine Electronics INSTALLATION MOUNTING The AP Wireless Remote Control (AP WRC) can be mounted anywhere inside the boat’s cabin where it will be protected from water and mechanical damage. There are two flanges on the box which have holes provided for mounting with screws (2) to any flat surface. Any orientation of the box is acceptable but take into account access to the on/off switch when selecting a mounting location and orientation.
PAGE 3
MADMAN Marine Electronics Connect Black Wire to 2 (0V) Connect White Wire to 4 (SeaTalk) Connect Red Wire to 1 (12V) Figure 3 - Electrical Connection Detail SPECIFICATIONS Electrical Supply Voltage 12V Standby Current (no buttons pressed) < 45mA Operating Current (multiple buttons pressed) < 100mA Internal Fuse Type M205 Glass Fuse (20mm) Internal Fuse Rating 200mA (normal blow) Transmitter Range 50m (direct line of sight) Transmitter Battery 2 x CR2016 button cell (user replaceable) V2.
PAGE 4
MADMAN Marine Electronics INITIAL TEST 1. Confirm the Autopilot has power to it by checking that the display is on and displaying a value. Test the Autopilot operates as per normal from the Autopilot’s own buttons by first pressing the ‘Auto’ key and then pressing the black buttons to alter position by 1 and 10 degrees to both port and starboard. 2. Switch on the AP WRC at it’s on/switch (switch to ‘I’). 3.
PAGE 5
MADMAN Marine Electronics OPERATION The fob (transmitter) buttons replicate the four black buttons on the Autopilot and provide the same course changing and auto-tacking functionality. In addition, the Autopilot mode can be changed between Auto and Standby from the fob. The fobs supplied have a range of around 100m so the AP WRC will work from any position on your boat. The main unit does not need to be in direct line of sight with the transmitter.
PAGE 6
MADMAN Marine Electronics TROUBLESHOOTING SYMPTOM CAUSE REMEDY Autopilot does not respond to fob (transmitter) button presses Autopilot is not turned on. Check that the Autopilot display is on (meaning it has power to it). Check that the on/off switch of AP WRC is switched on (‘I’ position depressed). Press any of the fob buttons while listening for a clicking sound from the box of the AP WRC. If a clicking sound can be heard then the AP WRC has power and is responding to button presses.
PAGE 7
MADMAN Marine Electronics V2.
PAGE 8
MADMAN Marine Electronics Tested Autopilot Models The AP-WRC is known to work on the following Raymarine autopilot models: ST1000+ ST2000+ ST4000+ SALES & SUPPORT For all sales and support enquiries, contact Neil Finlayson Ph. +61 (7) 3390 1408 E. nfinlayson@gmail.com www.madmanmarine.com V2.