Specifications

Chapter 3: Installation

This chapter describes how to install the ST60+ Rudder Angle Indicator

instrument and associated transducer.

Rotary and linear Raymarine Rudder Angle Transducers are available for use with

the ST60+ Rudder Angle Indicator instrument.

If the instrument is being installed as stand-alone, the transducer cable is

connected to the rear of the instrument. If being installed as part of a system

incorporating a SeaTalk Autopilot, the transducer is connected to the Autopilot.

For advice, or further information regarding the installation of this equipment,

please contact the Raymarine Product Support Department or your own National

Distributor.

3.1 Planning your installation

Before starting the installation, spend some time considering the best positions

for the instrument, such that the

Site requirements

and the

EMC installation

guidelines

are satisfied.

Site requirements

Transducer

The siting of the Rudder Reference Transducer depends on the type of vessel.

Fitting details and dimensions are given in the

Fitting transducers

section of this

chapter.

Instrument

ST60+ instruments can be fitted either above or below deck, provided that the

rear of the instrument is sited where it is protected from contact with water.

Each instrument must also be positioned where it is:

• Easily read by the helmsman.

• Protected against physical damage.

• At least 9 in (230 mm) from a compass.

CAUTION: Keep the rear of the instrument dry

Keep the rear of instrument dry. Failure to observe this caution

could result in damage if water enters the instrument through

the breathing hole or comes into contact with the electrical

connectors.

81266_1.book Page 9 Monday, December 5, 2005 9:28 AM