Product specifications

Chapter 6: Further Chart Operations 6-7
Cursor Echo
➤ To cancel the MOB, press and hold the MARKS key for 2 seconds.
The chart is re-drawn at its previousscale, and the MOB symbol and data box
are removed.
Note: The MOB procedure can also be initiated or cancelled if the appropri-
ate SeaTalk message is received by the display unit.
6.5 Cursor Echo
In a combined radar/chart display, or in a system with a radar display
connected via SeaTalk, you can set the display to enable cursor echo. Cursor
echo (accessed from System Set Up, described in Section 7.3) enables you to
displaya radarcursoron the chartpicture,or achartcursoronthe radarpicture
(youcannotdisplaya remotechartcursorina chartwindownora remoteradar
cursor in a radar window).
The following options can be toggled ON or OFF:
• RadarCursorIn:displaysthe cursor from another radar on the chart dis-
play or chart window (default - OFF).
• Chart Cursor In: displays the cursor from another chartplotter on the
radar display or radar window (default - OFF).
Note: The remote display must have SeaTalk Cursor Out enabled.
Raymarine recommend that in multi-display systems, you do not enable Cur-
sor Out on more than two displays. If multiple displays have cursor out en-
abled, the cursors will not be displayed simultaneously, but will flash on/off.
• SeaTalk Cursor Out: enables the output, onto SeaTalk, of the display’s
own cursor (default - OFF).
• CursorEchoLocal:echoesthe cursorpositionbetweenopenwindowson
the same display (default - ON).
If you set the options to OFF, no cursor echo information is displayed.
When the appropriate option is switched on, the display shows its own cursor,
plusthe cursor of theotherdisplaywithappropriatecursortext(RDR orCHT)to
indicateits origin. This means that you could move the cursor over a target on
the radar display, and check the identity of the target by looking at the radar
cursor position on the chartplotter.
MARKS