User guide

Quick Start guide for the Maxi And Dual Maxi Display
3
www.raymarine.com
Backlighting
To adjust the display backlighting press and hold , then use and to
select from OFF, or levels 1,2,3.
Automatic Pages
You probably want a different page shown on your Maxi Display for each leg of the
course. The Maxi display makes this easy by providing a special page: the AUTO
LEG page. Using this feature, you can programme your Maxi Display to show
exactly the information you require for each leg of the course without the need to
manually change pages at each mark rounding.
For example, consider a boat with
three Maxi Displays on a mast
bracket. The diagram shows a
typical selection of pages for
different legs of the course.
Programming these pages into
the Autoleg page before the race
automatically shows the selected
information for the appropriate leg
of the course; leaving the tactician
free to concentrate on the race.
To programme the Autoleg page:
Use your Remote Display to select your Maxi Display for remote control.
It is a good idea to programme the remote control display list of your Remote
Display to show your Maxi Displays in the same order as their physical location
on the boat. See the Remote Display user guide.
Press and hold to enter setup mode in the Autoleg chapter.
Use and to select a leg.
Then use , followed by and to select the data page to be
displayed.
A further press of confirms the selection.
When finished, press and hold to exit setup mode.
you can select Simple or Advanced mode for configuring the legs. See the full
user guide for further details.
using the Page Hiding function to eliminate duplicate pages across displays
reduces the time and key presses required if a manual reconfiguration of the
data displayed becomes necessary. See the full user guide for details.