User`s manual

Interfacing RNS 37
Integrated system checks
When RNS is installed on your PC and connections have been made to hsb
2
and
SeaTalk, carry out the following checks:
General
Power up the whole system including PC, hsb
2
displays, instruments and any other
navigation equipment that is connected to the system.
SeaTalk
1. Check GPS setup page on one of your Raymarine hsb
2
displays and ensure that
there is a FIX.
2. Select the chart screen on RNS and click
Find Vessel . Make sure that the vessel
symbol is centered on the screen in the correct location. If it is not check all SeaTalk
connections.
3. Check Nav data (a half- screen data page) on a Raymarine hsb
2
display. This should
show available SeaTalk data from instruments (wind, speed, depth, etc.) and auto-
pilot (heading, rudder position, pilot status, etc.).
4. Select suitable databoxes on RNS and ensure all SeaTalk data is displayed.
hsb
2
1. Check on one of your Raymarine hsb
2
displays hat all the expected options (chart,
radar, sonar) are available by pressing the DISPLAY button.
2. Set up RNS to show all of the same options as listed in 1. Make sure the radar and
sonar picture match from your hsb
2
display to RNS. If they do not, check all hsb
2
connections.
3. Chart data an be shared via hsb
2
. With a chart cartridge installed in a Raymarine
hsb
2
display, check that the same cartography is displayed on RNS.
On the RNS chart page, turn raster charts OFF, and C-Map ON. Click the
RANGE
button to zoom in and check that the chart data is correct.