Specifications

8 Ray240 - Service Programming Kit
Ray 240 programming procedure
Introduction
This section details the programming procedure for the Ray 240 base unit after
successful download of the latest software files.
Programming the base unit
To program the Ray240 base unit:
1. Plug the programming dongle into the USB port of your PC.
2. Switch off and remove the power cable from the Ray240 base unit.
3. Disconnect the handsets, interface cables and aerial connection from the base
unit.
4. Remove the top cover of the unit.
The top cover is removed by pressing and hold in the tab on the side of the
unit and lifting the top cover up and to the left to clear the heatsink.
5. Connect the 6-way cable from the programming dongle into the Ray 240 base
unit PCB ensuring correct orientation and alignment.
T
op cover
release clip
Progamming
dongle connector