Specifications

6 Operation/Wiring

supply to our products, and starter motor transients, can cause

the equipment to reset. This will not damage the equipment,

but may cause the loss of some information and may change

the operating mode.

• Raymarine specified cables are used at all times. Cutting and

rejoining these cables can compromise EMC performance and

so must be avoided unless doing so is detailed in the installa-

tion manual.

• If a suppression ferrite is attached to a cable, this ferrite

should not be removed. If the ferrite needs to be removed dur-

ing installation it must be reassembled in the same position.

The following illustration shows typical cable suppression ferrites

fitted to Raymarine equipment. Always use the ferrites supplied

by Raymarine.

Connections to Other Equipment

If your Raymarine equipment is to be connected to other

equipment using a cable not supplied by Raymarine, a

D3548-2

81166_5.book Page 6 Friday, February 2, 2007 11:47 AM