Installation guide

MK II Wheel Drive 9

4. Align the cover with the wheel drive:

• the two pre-drilled holes (marked with an arrow) must line up with their matching pair

of threaded inserts on the drive ring (also marked with an arrow)

• make sure that the other spoke clamp holes align with their threaded inserts

Note:

The cover will only fit back onto the wheel drive when you have aligned the two parts correctly.

5. Fit the cover back onto the wheel drive:

• press the cover in the three places shown on the diagram below to push each of the

posts back into its locating socket

Note:

This step is easier with the clutch engaged.

Pre-drilled holes

(marked with arrow)

Pair of threaded inserts

(marked with arrow)

Drive ring

Front cover Drive unit

D8896-1

D8897-1

TOP

87063_1.book Page 9 Monday, December 19, 2005 3:22 PM