Installation guide

MK II Wheel Drive 15

Note:

If the wheel is bent or the wheel drive is off center, the pin will move up and down in the back

plate slot. As long as the pin does not hit the top or bottom of the slot, this pin movement will not affect

the drive unit’s performance.

13. When you have checked alignment, fully tighten all four screws.

Connecting to the course computer

When you have attached the pedestal bracket, you need to connect the wheel drive to the

course computer. The drive unit is supplied with 4.5 m (15 ft) of 2-core cable with a

waterproof socket at one end.

1. Connect the socket to the plug on the wheel drive’s motor tube:

• remove the socket cover

• pull back the plug cover

• align the locking ring, plug and socket as shown below

• push the plug firmly into the socket

• turn the locking ring 90° clockwise

• make the connection waterproof by pulling the plug cover across so it protects the

plug and socket

Note:

To remove the plug, pull back the cover and turn the locking ring 90° anti-clockwise. If you dis-

connect the socket for any reason, always use the attached rubber cover to protect the socket.

2. Route the cable through the pedestal (or guard rail) and back to the course computer:

D8905-1

CablePlug cover

(pulled back)

Locking ring

Contact

Socket

Socket coverMotor tube

Plug

87063_1.book Page 15 Monday, December 19, 2005 3:22 PM