Installation guide

14 MK II Wheel Drive

8. When the pedestal bracket is correctly positioned and aligned, mark around the inside of

the slots, then remove the bracket.

9. Use a center-punch to mark the center of each slot, then use the smaller supplied drill bit

to drill a 4.0 mm (

in) diameter hole.

Note:

Drill at right angles to the pedestal surface.

10. Hold the bracket in place then lightly tighten the four cross-head screws (No 10 x

in).

As you do this, make sure the bracket is correctly aligned.

11. Replace the wheel, making sure that you locate the pin in the correct slot (slot 1 or slot 2).

12. Turn the wheel with the clutch off to check that the bracket is correctly positioned and

aligned.

D8903-1

154 mm

(6.1 in)

D8904-1

87063_1.book Page 14 Monday, December 19, 2005 3:22 PM