Reference Manual Part 2

G-Series Reference Manual 184
17.1 The engine monitor
The engine monitor toolbar gives you access to five preconfigured
data panels. You can customize these panels in the same way as
you do in the data application. For more information about custom-
izing data panels, see Customizing data panels on page 180.
17.2 Setting up the engine monitor
Before you use the engine monitor, you need to:
• Customize a page set to include an engine monitor window.
• Set the number of engines and the maximum tachometer range
to reflect your particular vessel.
For information about how to do customize page sets, see Choos-
ing page sets on page 25.
To set engine and tachometer values
1. Open the Panel Setup Menu (with an engine monitor window
active, press the MENU button).
2. Set the number of engines.
3. Set the maximum tachometer range.
Temperature and fuel units
Engine temperature units (
°
F or
°
C) and fuel units (liters, imperial
gallons or US gallons) are defined in the System Setup Menu under
Units Setup.
17.3 Available data
The table below summarizes the data contained in each pre-config-
ured data panel (available on the softkeys).
0 0
25 25
50 50
75 75
100 100
% %
Fuel 1 Fuel 2
Fuel Rate
11.61
gals/h
Fuel Rate
13.95
gals/h
D7516_3
ENGINE
ENGINE &
FUEL
ENGINE &
RESOURCES
TWIN ENGINE
FUE
L
R
ESOURCE
S
Panel Type
D8953_1
Data content
Tacho &
engine hours
Oil pressure
Engine coolant
temperature
Boost
pressure
Alternator
Fuel level
(tanks 1 & 2)
Fuel rate
Total fuel
Engine
Engine
& fuel
Fuel
resources
Engine &
resources
Multi
engines (3)