User's Manual

External Power Connections

To connect an external 9 to 30V DC power supply to the display head

from either a portable battery or the vessel's existing power system.

1. Drill two 7mm holes marked "P" on the mounting template and

smooth them together with a sharp knife or small file.

2. Pass the supply cable through the new hole and attach the supplied

crimp spade receptacles.

3. Remove the blanking plug from the rear of the display to expose the

terminals.

4 Stick the supplied gasket on the back of the display.

5. Taking care to connect the correct polarity push the receptacles

firmly onto the spades on the rear of the case.

6. Mount the display head securely in position following the steps

shown above.

7. Clamp the cable securely close to the display.

Dual Maxi Display