User's Manual

Installation
27
www.tacktick.com
Where there is no access to the rear of the mounting surface
Warning: only use the screws provided with the display and take care
not to over tighten the screws. Incorrect or overtightened screws may
cause the moulding to crack; this will invalidate your warranty.
Position the supplied Template carefully before starting.
1. Drill four 2.5mm holes as marked on the template.
2. Refer to the diagram below. Using your fingers, carefully snap the
facia of the display off the main body by pulling in the direction of the
arrows.
Warning: take care not to drop the button pad.
3. Remove the four captive M4 nuts from the plastic moulding and
attach the display to the mounting surface using the four self tapping
screws provided.
4. Check the display is perfectly level; carefully position the button
insert into the slot and snap the facia back into position.
Where access is available to the rear of the mounting surface
Warning: do not bolt through from the front or replace the plastic nuts
with metal nuts. This may cause the moulding to crack and will invalidate
your warranty.
This method allows for maximum security of a permanently mounted
display. Position the supplied template carefully before starting. Use
bolts of a suitable length inserted from the rear. The internally fitted
plastic nuts will prevent overtightening.
Note: If the internal plastic nuts are displaced or become damaged,
remove the bezel as described above and replace with the spare nuts
provided.
Warning: take care not to drop the button pad.