User's Manual

Demonstration Mode

Allows the display to show information when NOT installed as

part of a Micronet system for demonstration purposes only.

Displays will return to default OFF on power down.

Factory Reset

Returns all the calibration settings to the factory default values.

Health Chapter

Software Version/Network Nodes

Displays the software version, battery level and charge rate to

assist in troubleshooting and fault finding.

If the display is the "Master" (the one used to switch on the

system) then the number of items (nodes) in the system will be

shown. If the display is a "Slave" (was switched on by the system) then

the signal strength to the "Master" will be shown in place of the number

of nodes.

Hull Transmitter Signal Strength

Shows the software version (large digits), signal strength and

battery condition (level and charge rate) of the Hull Transmitter to

assist in trouble shooting and fault finding

Similar information pages are available for other transmitters if they

areconnected to the micronet network, for example:

Wind Transmitter (identified as WIND)

Wireless (NMEA) Interface (NMEA)

Mast Rotation Transmitter (MAST)

Man Overboard Transmitter (MOB)

Dual Maxi Display