User's Manual

Dual Maxi Display
14
www.tacktick.com
4.2 Audible Signals and Alarms
At stages during its operation your Dual Maxi Display will beep to
indicate alarms or moments of importance.
Power-up The display will beep once as it switches on.
Button Press The display will beep once each time a button is
pressed. A second beep is issued after a 2 second hold
down of the button.
Timer The display will beep once at each minute of the
countdown.
With 1 minute left to go a beep will sound every 10
seconds.
With 10 seconds to go a beep will sound every second.
Countdown complete will be indicated by a single burst
of three beeps.
Alarm Continuous bursts of three beeps will indicate an alarm.
The alarm activated will be indicated on the display,
accompanied by the flashing (BELL) symbol.
Pressing any button will silence the alarm. See fault finding section,
page 29.
The Alarms below will be indicated on the Dual Maxi Display, however
they must be configured using another Tacktick Micronet display
connected to the network. See the appropriate display user guide for
details of configuring alarms.
Depth Shallow Alarm
The water depth has fallen below the preset alarm level.
This alarm does not sound as the depth increases above
the preset alarm level.
Depth Deep Alarm
The water depth has increased above or fallen below the
preset alarm level.