User's Manual

S39 Boat Show (Demonstration Mode)

Allows the display to show information when NOT installed as

part of a Micronet system for demonstration purposes only.

Displays will return to default Off on power down.

S40 Factory Reset

Returns all the calibration setting to the factory default values.

Health Chapter

S41 Software Version/Network Nodes

The top line of each Health chapter screen shows the software version

of the Remote Display, battery level and charge rate to assist in

troubleshooting and fault finding.

If the display is the "Master" (the one used to switch on the

system) then the number of items (nodes) in the system will

be shown.

If the display is a "Slave" (was switched on by the system)

then the signal strength to the "Master" will be shown in place

of the number of nodes.

S42 Hull Transmitter Signal Strength

Shows the signal strength, software version, battery level and

charge rate of the Hull Transmitter to assist in trouble

shooting and fault finding.

S43 Wind Transmitter Signal Strength

As above but for Wind Transmitter information.

S44 Wireless (NMEA) Interface Signal Strength

As above but for Wireless (NMEA) Interface information.

Setup and Calibration