User's Manual

mn100 Digital Display
28
5 Installation
5.1 Tools Required and Parts List
1. 2mm or 5mm Drill Bit
(7mm if power connection
required)
2. Power Drill
3. Cross Head Screwdriver
1. Mounting Template
2. Display Bracket
3. Mounting Screws (3)
4. Mounting Bolts (3)
5. M4 Studs & Thumbnuts (3)
6. Sealing Gaskets (4)
7. Double Sided Tape
5.2 Precautions and Positioning Advice
Ensure mounting surface is flat.
Leave space between instruments for sun covers.
Leave space to remove instrument from bracket (if used).
Avoid areas where damage may occur (winch handles, feet, warps
etc.)
Select a flat, smooth, surface for mounting and use the Template
provided to select a suitable position for mounting your Micronet
instrument.
Check for clarity of vision and ease of access to the control buttons,
it is recommended that instruments are positioned such that your
arm does NOT pass through the spokes of the steering wheel when
operating the buttons.
Contrast is limited at night when an instrument is
viewed from beneath. Avoid mounting instruments in
a position where you will look upwards to view them.
Operation
9
Pressing the
button at any time will move on to the next
Chapter and on scrolling through the Chapters the Page last
selected in that Chapter will be displayed. Both Chapter and Page
selection will scroll back to the first Page once a cycle has been
completed.
Full Chapter and Page Selection
For a full description of each page refer to items 1 to 32 on the
following pages.