User's Manual Part 2

PART I. User & Installation Manual
1417WGC/WCC 107
4.4.3 Sleep Mode
1. Click “Edit” under the Calibration & Acquisition tab.
2. Under the “Sleep Timeout” setting, enter a designated time for the detector to go into Sleep
Mode.
 Sleep Mode does not apply when set to zero.
 Power consumption is reduced by 40% when Sleep Mode is used.
3. To turn off Sleep Mode, attempt to acquire an image or press the power button on the
detector just once.
 A normal image can be acquired after 10 seconds Sleep Mode has been turned
off.