Specifications

1. Open all valves to allow oil into the oil control valve. It
may be necessary to purge the oi line to prevent
airlocking.
2. Lift the reset lever on the on the oil control valve and
turn cooker oil control knob C to No. 6 setting. See
Figs. 11 and 12.
Oil should enter the burner base in due course and after
about 10-15 minutes, the depth of the oil should have
settled to a static depth of 5-6mm deep where oil enters
the oilways of the burner base.
To correct the oil depth, adjust the oil control valve
height via the adjusting screws between the valve and
mounting bracket.
Re-check the oil burner and valve are level in all
directions.
Installation Instructions
7
Fig.9 Boiler Model Only
.Fig. 10 DESN 515835
Fig.8 Burner assembly - 308K Boiler Model
Fig. 8A Burner assembly - 300K Non-Boiler Model
DESN 511029
BURNER LID
INNER PLATE
(SS)
CARBON LEG
ASSEMBLY
SET OF SHELLS
BURNER BASE
DEEP WELL
BURNER BASE LID
BURNER WICKS
DEEP WELL
BURNER BASE LID
TOP PLATE
CARBON LEG
ASSEMBLY
BURNER LID
OUTER PLATE (SS)
BURNER LID
FLAME RING
(CI)
CHECKING THE BURNER OIL LEVEL