User Manual

5
SETUP INSTRUCTIONS
1. Start with one of the light stands. Unlock the legs by turning
the leg adjustment locking knob. Spread the leg sections until
the leg struts are parallel to the floor. Re-tighten the knob.
2. Raise the height of the stand by loosening the shaft height
locking knobs. Start with the lowest knob, and raise each
section to the desired height. Re-tighten each knob.
3. Configure the second stand to match the first.
4. Place the two stands where you want the backdrop to hang.
You’ll be able to adjust them once you get the crossbar in
place.
5. Connect one crossbar section to another by inserting the
pegged end into an open end. Twist the two sections until the
pegs click into place through the holes.
• For a 4.9 ft. crossbar: Connect sections A and C.
Important! The maximum weight load for the 4.9″ft. crossbar is 6.5
lb. That’s equivalent to one roll of 53″in. wide seamless paper
roll w/ core.
• For a 9.8 ft. crossbar: First connect the two B sections.
Then connect section A to one of the B sections, and
section C to the other B section.
Important! The maximum weight load for the 9.8″ft. crossbar is 4.4
lb. That’s the equivalent of a 10″ft. (W) × 12 ft. (L) muslin sheet.