User guide

11
Using the Ray USB Power Adapter:
 Firmly insert the Ray USB Power Adapter connector into the Ray
Projector.
 Insert the power adapter firmly into the power outlet (the
ModeLight should start flashing after a few seconds).
Caution:
Do not connect, disconnect or clean the Ray USB Power Adapter
with wet hands.
Use ONLY the Ray Power Adapter to charge the Ray.
Note:
The Ray USB Power Adapter may become warm during normal use.
Be certain to allow adequate ventilation around the Ray USB Power
Adapter.
Always exercise caution when handling the Adapter.
Never use the Ray USB Power Adapter if any of the following
conditions exist.
 The power cord or plug has become frayed or damaged.
 The adapter is exposed to rain, liquids, or excessive moisture.
 The adapter case has become damaged.
 You suspect the adapter needs service or repair.
Contact Ray for a replacement.
DO NOT LOOK DIRECTLY INTO THE LENS OF RAY.