Instruction manual

Basic Connection:
The connection diagram represents the installation.
To activate the
Ray Pico Projector , connect any TV video output from a
camera, camcorder, iPod®, iPhone™, MPEG Video player, or phone to
the TV input terminal of the BEAM.
4
Getting Started with Ray
Set-up Information:
Slide the ON/OFF switch to the ON position. The Power/Charge Light
will flash at a rapid rate about once every 1/2 second (approximately
120 flashes per minute). If the AC adapter is not attached and the light
does not flash, the Pico Projector Battery must be CHARGED.
Flashing Light
OFF ON