Use and Care Manual

5. Attach the assembled cross bar from step 4 to the second assembled base from
steps 1-3, using the second cross bar plate (l), and two (2) of the 2 ¾″ hex bolts
(l), with two (2) washer and a lock nut on each bolt to attach the plate to the
frame.
6. Use two (2) 3 ½″ hex bolts (m), with two (2) washers and a lock nut on each, to
attach the rack arms (I) to the frame. Attach the first arm to the lowest two holes
possible, and the second arm in the highest two holes possible. Repeat on the
other side. (You may nd it helpful during this part of the process to use one wrench to hold
the bolt in place and use a second wrench to turn the lock nut).
7. The kayak rack should be fully assembled. If possible, drill a bolt down into the
oor with the anchor brackets (r) to stabilize the unit in a permanent position,
preventing it from tipping over. If not, make sure that the weight is always
evenly distributed, and if only storing one kayak, store it on the lower rack.
Assembled Dimensions: 52” H x 94” W x 26” D (132.1 x 238.8 x 66 cm)
SPECIFICATIONS
SPECIFICATIONS 10ASSEMBLY INSTRUCTIONS 9
A
B
C
J
A
C
O
O
N
N
O
N
B
D
O
K
E
G
K
K
B
D
H
l
O
O
I
I
P
O
I
I
P
O
b
b
d
d
l
l
A
B
C
J
A
C
P
P
P
O
O
O
B
D
O
K
E
G
K
K
B
D
O
K
B
D
O
K
B
D
O
K
i
i
t
t
i
i