Use and Care Manual

1. Locate parts a, b, and c. Make sure the welded nuts on the bottom of the bases

(a) are facing down. Fit the base post (b) over the top of the base (a) and align

the base leg (c) with the two (2) holes on the side of base (a) and on the bottom

of base leg (b). Use the carriage bolts (j) with washers and lock nuts to connect

the base leg (c) to the base (a) as shown in the parts diagram below. Repeat this

process for the second set of a, b, and c parts.

2. Attach the leveling feet (s) by placing two (2) hex nuts (that come with each

leveling foot) and an anchor bracket (r) on each one. Make sure the anchor

bracket has one nut on both sides of it. Lean the assembled base to one side

and attach the leveling feet (s) to the welded nuts on the underside of the base (a)

and base leg (c). Repeat this process on the second assembled base.

ASSEMBLY INSTRUCTIONS

3. Insert the post (d) into the base post (b) making sure the empty side of the post

(d) faces the base leg (c). Using two (2) ¾″ hex bolts (k), each with a locking

washer and a thick washer, attach the post (d) to the base post (b), making sure

the welded nuts are facing the rear and are aligned with the corresponding holes.

Repeat this process on the second assembled base post.

4. Place the cross bar plate (l) on one side of the post (d) and the base post (b) and

place the cross bar end (male) (e) on the opposite side. Use two (2) 2 ¾” hex

bolts (l) to attach the cross bar plate and the cross bar end (male) to the holes

where the post and base post connect. Then, connect the central cross bar (g) to

the cross bar end (male) using two (2) ¾” hex bolts (k). Finally, connect the cross

bar end (female) (f) to the central cross bar using two

more (2) ¾” hex bolts (k).

ASSEMBLY INSTRUCTIONS 7 ASSEMBLY INSTRUCTIONS 8