Specifications

RV-M7 Technical Manual
24
when the line is negated).
0 = Disable
ATCS
Set automatic on-line after ATDT command – 0: stay in
command mode after exiting ATDTxxxx command. This is
the default configuration. 1: Exit command mode after
receiving an ATDTxxxx command. See technical bulletin
AN163 for more information about this command.
1 = Enable
0 = Disable
0
ATCH
Configure Hardware Flow Control – Enable (1) or disable
(0) flow control. When enabled, the modem will monitor the
RTS line, and if it is negated, stop sending data out the serial
port. If disabled, the modem will ignore the state of RTS, and
always send out characters.
1 = Enable
0 = Disable
0
ATCT
Command Time Out – If no valid commands have been
received via the serial port within this time period (in
milliseconds), modem returns to normal operation mode from
Command mode. If the CONFIG button inside the M7 is
pressed, this parameter will be automatically set to 60000.
Range: 100-60000mS
60000
ATDR
Set Destination Address and exit command mode– Sets
address of the modem to send data to. Note, this parameter is
entered in HEX format. Each digit may be a
0,1,2,3,4,5,6,7,8,9,A,B,C,D,E,or an F. After setting the
destination address, the unit exits the command mode, and
goes on-line. See technical bulletin AN163 for more
information about this command.
Range: 0-FFFF
-
ATDT
Destination Address to call– Sets address of the modem to
send data to. Note, this parameter is entered in HEX format.
Each digit may be a 0,1,2,3,4,5,6,7,8,9,A,B,C,D,E,or an F.
Range: 0-FFFF
1234
ATE
Echo – Character echo set on (E1) or off (E0). This applies to
the Command Mode only.
Range: 0 , 1
1 (echo)
ATF
Display frequencies – Display all of the frequencies
programmed into all of the channel memories.
N/A
ATFT
Transmit Frequency – Program the transmit frequency for
this channel. Enter in Hz or in MHz. The frequency will
automatically be saved in non-volatile memory (flash) for this
current channel number.
Range: See product data
sheet. For MURS products,
frequency cannot be changed.
See product
data sheet.
ATFR
Receive Frequency – Program the receive frequency for this
channel. Enter in Hz or MHz. The frequency will
automatically be saved in non-volatile memory (flash) for this
current channel number.
Range: See product data
sheet. For MURS products,
frequency cannot be changed.
See product
data sheet.
ATFX
TX and RX Frequency – Program the receive and transmit
frequency for this channel. Enter in Hz or MHz. Same as
issuing an ATFR and an ATFT command. The frequency will
automatically be saved in non-volatile memory (flash) for this
Range: See product data
sheet.
N/A