Specifications

M7 GX Technical Manual 51 Raveon Technologies Corp.
200mS, then the TDMATIME must be at least 17.4 seconds so a value
of 20seconds for the TDMA time is appropriate.
10.6. Debug Related Commands
Bench Testing
(Must be in command mode to test. Enter +++ at the keyboard to put unit into config/test mode.)
ATTD x Various transmit test routines.
0 = Go back to normal mode. Stops the test.
1 = Random data transmit.
2 = Hop up/down one channel
3 = Force PLL to fast lock mode
4 = Transmit all 0s
5 = Transmit all 1s
6 = Enable the test points on the PCB.
7 = Transmit CW on center of channel
8 = Transmit preamble (101010 pattern)
SHOW Display an overview of the configuration.
Ping xxxx Ping another modem over the air. Transmits a request to xxxx to see if
xxxx can hear the sending station. If it does, it answers with a response
transmission, containing its ID and the signal strength of the reception. .
ATST Display statistics of how the modem is working.
ATST 1 Display statistics of how the modem’s GPS is working (-GX version only).
AT$5 Display RSSI. It will scroll the reading until another character comes in
the serial port.
Packet Counter
The packet counter mode will output packet count statistics once per minute. It will
output the number of packets received in the last minute as well as the running
total. T
ATPE Begin counting and displaying the packet counters every minute
ATPE 1 Reset the packet counters back to zero
ATPE 2 Stop counting and displaying packet counters
Upon power up, the packet counter feature is always disabled.
10.7. Tune-up and Alignment
Do not key the transmitter for more than 30 seconds out of
every 150 seconds if the RF power is set above 2 watts.
Radio calibration and alignment is performed using the ATRx commands. The RV-
M7 modem has been factory calibrated, in should not require any re-calibration
when installed, or when changing frequency or channel. Unless the user is trained