Installation guide

FireLine System Protocol Manual 18 Raveon Technologies Corp.
The only Network Services that should be enabled are TCP sockets are
ADDP and HTTP.
The FireLine Ethernet is ready to operate using a TCP Socket. To test it, you
can use a Telnet program. Open a telnet session, using port 2101. There will be
no login prompt. Simply type characters in the telnet window, and the FireLine
Ethernet wills send them over the air. All data received over-the-air will be
transferred over the network to the Telnet program.
7. Specifications
Standard: .................................................................. IEEE 802.3
Physical Layer: ..................................................... 10/100Base-T
Data Rate: ....................................... 10/100Mbps (auto-sensing)
Mode: .......... Half-duplex and full-duplex support (auto-sensing)
Connector: ......................................................................... RJ-45