Installation guide

FireLine System Protocol Manual 11 Raveon Technologies Corp.
2. From the main menu, select “Serial Ports”. This will display the current serial
port configuration as shown below.
3. Click on Port1, to display its configuration. The port profile shoul dbe “Console
Management” as shown below. If it does, skip to step 5, if not, perform step 4.
4. If the port is not in Console Management profile, click on “Change Profile, and
select “Console Management” and press “Apply”.
5. Click on “Basic Serial Settings” on the bottom of the Serial Port Configuration
screen. Set the serial port parameters as shown below and press “Apply”.
The baud rate must be 57600bps, as that is the internal serial port baud rate
that the FireLine’s modem uses to communicates with the Digi Connect