User Manual

Company Confidential 20 Raveon Technologies Corp.
SL Serial Number – Reads and returns a unique module
serial number.
Read Only
1 - 65525
unique
SH
Show – Display the configuration of the modem. This
will return a page of ASCII characters, showing the
main configuration parameters.
none
None
SV
Save – Save all the parameters to EEPROM. This
command must be used if changed parameters are to
be stored in non-volatile memory, and used next time
the modem is powered up. Modem exits configuration
mode after this command is executed.
none
None
TD
Transmit Random Data – When issued, the modem
will begin sending random data. Entering a <CR> will
terminate the transmission.
0 = Go back to normal
1 = Random
2 = Hop up/dn one channel
3 = Force PLL to fast
4 = TX all 0s
5 = TX all 1s
6 = Test Points ON
7 = Transmit CW
8 = Transmit 1010101…
TM
Serial Port time out – Number of uS of no activity
before transmitting.
Range: 0 - 5000000
20000
TT
Max Packet Size – Set the maximum number of bytes
in an over-the-air packet.
1 - 512
240
VR
Firmware Version – Returns firmware version
currently loaded on the module.
Read Only, 3
characters
none
&F
Restore Factory – Restore the factory default values.
This command will not erase the calibration values in
the flash unless the parameter is the three-digit string
“123”. After this command executes, the modem will
still be in the CONFIG mode.
None to maintain
calibration, “123” to
erase everything.
none
** indicates values that are calibrated in the factory and are unit-specific. If the
“Radio Type” is changed, these will need to be re-calibrated.
Default Frequencies
Channel 1 464.500000