Technical Manual

Company Confidential 16 Raveon Technologies Corp.
Even though the serial baud rate reverts to 9600 baud when the CONFIG button is
pressed and the IO port is RS232, it will revert back to the settings programmed into
the M6 modem once the Command Mode is exited.
5.6. Exiting the Command Mode
There are three ways to exit the command mode. They are:
1. ATCN Issuing the ATCN. The M6 radio will exit the command mode, and begin
normal operation.
2. EXIT Issuing the EXIT. The M6 radio will exit the command mode, and begin
normal operation.
3. Time Out. After a pre-set amount of time (60 seconds is the factory default time),
the modem will automatically exit the Command Mode, and continue normal
operation. Changes will not automatically be saved. This time-out duration may be set
with the ATCT command.