User Manual

Prodigy™ Owners Manual 99301XXX
8
GROMMETED
HOLES
INSTALLATION
2. Carefully lift the bed base frame from the
shipping carton, keeping the unit top-
side-down.
3. Install (4) legs into the base frame. Simply
screw each leg into a tapped hole at each
corner of the base frame (FIGURE 1).
Insert casters into the bottom of each bed
leg.
CASTERS – PRESS-FIT
INTO BOTTOM OF LEGS
LEGS – SCREW INTO
TAPPED HOLE AT
EACH CORNER
FIGURE 1: Leg and caster installation.
4. Remove and extend out power cord from
the protective packaging.
POWER CORDS MUST NOT INTERFERE
WITH ANY ADJUSTABLE BED
MECHANISMS.
5. Remove the plastic packaging from the
bed base frame. Carefully rotate the base
frame over to position the bed top-side-
up.
6. Plug power cord into a working,
grounded electrical outlet. Note: an
electrical surge protection device is
recommended (not included).
7. Install batteries in hand control (4-AAA
size, included). Briefly activate all
functions of the bed with the hand
control to verify all features are in
working order. If bed does not operate,
refer to the Troubleshooting section of
this manual.
8. Return bed to the level position.
Mattress Retainer
9. Install standard mattress retainer at the
foot end of the bed base as follows:
a. Locate grommeted holes at foot and
sides of bed base (FIGURE 2).
FIGURE 2: Grommeted hole locations.
FOOT END OF BED BASE