User's Manual

2-28-08
REV C
ELECTRONIC SYSTEMS DIVISION – ST. LOUIS •
••
• 4372 GREEN ASH DRIVE •
••
• EARTH CITY •
••
• MO 63045-1231
TELEPHONE [phone] FAX [phone]
To create a Dependent Network use “Making a Coordinator Procedure” then “Control Box to Coordinator
Control Box Procedure” and then use “Hand control to Control Box Procedure” for all hand controls. Note
all salve node control boxes must be reset before the unit can be learned.
Learning:
Control Box Learn Modes:
1.) A control box can be put into learn mode by pressing its learn button and then releasing after
the status light turns on. When released the status light will flash fast to indicate the unit is in
learn mode.
2.) After powering up a control box the unit can be put into learn mode by pressing and holding
the control box learn buttons on the hand control for 10 seconds. The hand control will do a
slow yellow flash of the LED while the buttons are pressed. The control box can only go into
this mode for 60 seconds after power. Control box status light will flash fast to indicate the unit
is in learn mode.
3.) A control box can be put into learn mode by pressing the button on the power down box for
less than 2 seconds and then releasing. The light on the power down box will turn yellow and
then start flashing.
Making a Coordinator Procedure
If a control boxes is displaying a code of 11 the control box has been reset and must be initialized.
Place the control box in learn mode buy using on the three methods described in “Control Box
Learn Modes” the status light will stay on solid until if finds all the coordinators about 5 seconds
then start flashing fast this will last for 20 seconds. When this is done the status light will start
flashing slow to indicate that it has become a coordinator to save time in learning a hand control
can be learned to the coordinator when the status light is flashing fast see “Hand Control to
Control Box Procedure”.
Hand Control to Control Box Procedure
Place the control box in learn mode see “Control Box Learn Modes” wait for the light to start
flashing fast. Press and hold the learn buttons on the hand control the light will start out red then
switch to flashing yellow 2 short pulse then turn on solid. When the light on the hand control turns
green the hand control has been learned. If no control box is in learn mode the light will timeout
after 15 seconds no learn will taken place.
Control Box to Coordinator Control Box Procedure
Place the coordinator control box in learn mode this is control box with the status light flashing
slow see “Control Box Learn Modes”. When the light starts flashing fast place the non coordinator
control box in learn mode see “Control Box Learn Modes”. The status light on the non coordinator
control box will start flashing fast and then stop when the unit has learned. The status light will
then start the flash pause sequence. The coordinator control box will switch to a slow flash after it
acknowledges the control box has been learned. If the status light does not switch to a slow flash
the learn button can be pressed to clear learn mode.
Note a control box can only be added to a network if its communications has been reset.
Hand Control to Slave Control Box Procedure
Place the control box in learn mode see “Control Box Learn Modes” and wait for the status light to
start flashing fast. Press and hold the learn buttons on the hand control the light will start out red
then switch to flashing yellow 2 short pulse and then turn on solid. When the light on the hand
control turns green the hand control has been learned release the buttons. The status light on the
control box will stop flashing fast when it acknowledges the hand control has been learned.
Reset Communications:
Communications can be reset by holding down the learn button and powering up the unit. A reset
control box will flash a status code of 11.
Hand Control Button Timeout: