Specifications

Set Up Instructions:
1. Setting up the tripods: Upon removing the tripods from the bag
all knobs will be tightened. To set up the tripod, you will first need
to loosen the set screw on the leg brace. Pull the legs outward
from the center pole and then you will be able to push in a
downward motion on the top of the brace while holding the center
pole (See Figure 1). Continue pushing downward until the legs are
fully extended. Once the legs are fully extended, you will need to
tighten the set screw to secure the legs into position.
2. Setting up the extension poles: Your background stand comes
with five 3’ cross bars. The poles have been designed with a male
and a female end on each bar resulting in a slide and lock design
(See Figure 2). Simply slide the silver male end into one of the
female ends. Once fully inserted, turn the poles approximately 90
degrees until you feel a lock and the arrows on the stickers are
aligned with each other.
3. Attaching crossbars to the tripods: Each one of the tripods has a
reversible adapter on the top with a washer and a wing nut already
attached. To attach the cross bars to the tripods, simply unscrew
and remove the wing nut and the washer. On the cross bar there is
a hole on one side of the pole. Simply slide the pole onto the screw,
slide on the washer, then screw on the wing nut and tighten until
secure (See Figure 3).
Note: The crossbars can be set at various lengths. The minimum length would be the use of two
crossbars. To do so, you will have to use the two cross bars that have the holes on either end so that
they can be attached to the tripod stands.