Data Sheet

V-MOTION LITE - User Guide
10
3. Remove the plate and replace the Toothed Pulley on the motor’s shaft. Don’t let it slide
all the way to the bottom of the shaft, leave a margin of around 2mm from the bottom.
Use the 1.5mm Hex Key to tighten both set screws inside the pulley, locking it in place.
Important: Make sure one of the set screws is aligned with the flat part of the motor
shaft.
4. Pass one 25mm Screw through one of the holes on the Motor Plate, then through a
black spacer and finally screw it into the motor. Repeat until you’ve used the four 25mm
Screws and respective Black Spacers. Make sure you use the same holes from which
you removed the original screws, on step 2.