User`s guide

Macintosh
43
[Delay time between power on and SCSI bus reset]
Default value is 0. You can set delay time for some SCSI devices which hang
up if SCSI bus reset is issued right after the FR1SX gets powered. Set this
value to 2 for Castle Wood ORB drive, Canon FB620S or Sharp JX-370.
[Delay time between SCSI bus reset and SCSI command]
Default value is 1. You can set delay time for some SCSI devices which hang
up if SCSI command is issued right after SCSI bus resets.
[Delay time until 1394 transaction start]
Default value is 4.You can set delay time for some SCSI devices which will
not receive any command if a next command is issued right after Start/Stop
Unit command is issued.
[Max Payload Size]
Default value is 1024. You can set Max byte size in transferring IEEE1394
Read/Write DataBlock. Max size is 2048 Bytes. But, if a data error happens
during data transfer, you should set this value to 1024 Bytes to avoid the
error.
[Default]
When you click this button, the default settings will be loaded.
[Start Configuration setting]
If you click this button, the settings will be loaded. Then,