User`s guide

Macintosh

E.After the MacOS starting up, hook up the FR1SX/HDD to a FireWire port.

F.The icon of the SCSI HDD will be mounted on the desktop.

G.If you want to use the scanner again, unmount the HDD, remove it and

set the B’sCrew SIM FireREX1 enabled again with the [Extesions

Manager]. And then, follow Example 1-B to E.

(3)Example 3

If you have two FR1SX and hook up them to a scanner and HDD each

in daisy-chain, please refer to the following steps.

A.The SIM Driver mode on the FR1SX attached to the scanner must be set

enable(Default setting is enable). The SIM Driver mode on the FR1SX

attached to the HDD must be set enable(Default setting is enable).

You can set or reset this mode with the SCSI Configuration utility. Refer

to section B in the Chapter 4-2-1.

B.The B’sCrew SIM driver must be set enable.

C.Turn off your Mac and hook up the “SIM enabled” FR1SX and scanner

to a FireWire port.

D.Turn on the scanner. Please make sure the green LED of the FR1SX

comes on. If not, please check the Term-Power at the scanner SCSI

connector. Refer to Chapter 5-4 for more information.

E.Turn on your Mac and start MacOS.