User`s manual

Parameter description
6
6-26
6. Parameter description
Parameter
No.
Parameter name
Setting range
[Default value]
Description
FC-09
Position sensor
monitor resolution M
16 to 8192
[1]
Sets the division ratio M/N of the position sensor
monitor signal. This setting's description changes in
relation to the type of position sensor. A "Mismatch
error (E40)" occurs without outputting position
sensor monitor signals if invalid combinations are
set as listed in the following table. This parameter is
enabled by turning power off and then back on.
Position
sensor
selection
FA-81
Effective range Position
sensor
monitor
division radio
Invalid
combination
MN
FC-09 FC-10
inCE
(Note 2)
1
1 to 64 1/N
FC-10=
65 to 8192
(Note 2)
2
3 to 64 2/N
FC-10=
1, 2, 65 to 8192
1 to 8191
(Note 1)
8192
M/8192
FC-09=8192
FC-10=
1 to 8191
Note 1: The position sensor monitor division ratio is
set to "M/8192" when FC-10 is not equal to
8192. In all other cases, the position sensor
monitor division ratio is set to "1/N" or "2/N"
according to FC-09.
Note 2: The FLIP-X series resolution is 16384
pulses per revolution of the motor.
The PHASER series resolution is 1 pulse
per micrometer.
FC-10
Position sensor
monitor resolution N
1 to 8192
RDX [4]
RDP [1]
FC-11
Position sensor
monitor polarity
A
b
[b]
This parameter specifies which phase of the
position sensor signal, phase A or phase B, leads
the other phase when the motor runs forward. Set
this parameter to "b".
Setting Phase relation
b Phase B leads phase A.
This parameter is enabled by turning power off and
then back on.
FC-12
Phase Z output
selection
1PLS
nCunt
ECunt
qFort
[1PLS]
Sets the OZP and OZN terminal outputs. Set this
parameter to "1PLS".
FC-19
Command pulse
filter time constant
Lo
Hi
[Hi]
Sets the pulse train filter time constant as follows.
Setting Filter time constant
Lo 1 μs
Hi 0.2 μs
FC-21
Communication
baud rate
1200, 2400,
4800, 9600,
19200, 38400
[bps]
[19200]
Sets the baud rate used to communicate with the
PC (TOP software for RD series).
FC-22
Communication
bit length
7,8
[bit]
[8]
Sets the bit length used to communicate with the PC
(TOP software for RD series).