User`s manual

Parameter description
6
6-8
6. Parameter description
Parameter
No.
Parameter
name
Setting range
Default setting Units
Change
during
operation
RDX RDP RDX RDP
FA-23 Homing mode
L-F, L-r, H1-F,
H1-r, H2-F,
H2-r, CP
(Note 3)
Depends on model – –
t-F, t-r, S-F, S-r
FA-24
Servo OFF wait
time
0.00 to 1.00 0.05 s No
FA-25
Operation range
at machine
diagnosis
1 to 255 10 rotation No
FA-26
(Note 2)
Brake operation
start speed
0 to maximum
speed
30 min
-1
mm/s No
FA-27
(Note 2)
Brake operation
start time
0, 0.004 to
1.000
0.000 s No
FA-28
(Note 4)
Electronic
thermal level
20 to 105 Depends on model % No
FA-80
(Note 3)
Position sensor
type selection
inC, AbS inC – No
FA-81
(Note 3)
Position sensor
selection
Stnd, inCE,
AbSE1, AbSE2,
AbSA2, AbSA4
inCE – No
FA-82
(Note 4)
Position sensor
resolution
500 to 65535
(FA-81=inCE)
4096
Depends
on
model
pulses No
FA-85
(Note 1), (Note 3)
Linear scale
accuracy
0.01 to 655.35 1.00 μm No
FA-86
(Note 1)
Pole position
offset
8000 to 7FFF 0 – No
FA-87
(Note 1), (Note 3)
Linear scale
polarity
A, b b – No
FA-88
(Note 1), (Note 3)
Phase angle of
pole position
PHASE, LinE PHASE – No
FA-89
(Note 1), (Note 3)
Preset condition
for pole position
OrLP, OrLn OrLP – No
FA-90
(Note 1)
Hall sensor
connection
oFF2
oFF2 – No
oFF, CnCt
(Note 3)
FA-98
Initialization
mode selection
CH, dAtA
CH – No
AbS
(Note 3)
Note 1: Displayed on RDP only.
Note 2: Invalid on RDP.
Note 3: Do not change the setting.
Note 4: Set this parameter to the default value for each model.